
336 Audio Plug-ins
This is a single stage chorus effect. It works by doubling whatever is sent into it with a slightly
detuned version.
The parameters are as follows:
Rate
The sweep rate can be set freely with the Rate knob, without sync to tempo.
Width
Determines the extent of the chorus effect. Higher settings produce a more pronounced
effect.
Spatial
This sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
Mix
Sets the level balance between the dry signal and the effect. If Chorus is used as a
send effect, this should be set to maximum as you can control the dry/effect balance
with the send.
Shape
This switch changes the shape of the modulating waveform, altering the character of
the chorus sweep. Sine and triangle waveforms are available.
Delay
This parameter affects the frequency range of the modulation sweep, by adjusting the
initial delay time.
Filter Lo/Hi
These parameters allow you to roll off low and high frequencies of the effect signal,
respectively.
Related topics
Audio Plug-ins
Master Section
How do I add effects?
Presets
WaveLab 7
Kommentare zu diesen Handbüchern